Home >> Products >> Welded Wire Mesh >> Welded Wire Gabion box

Welded Wire Gabion box

Our Gabions Systems may
be supplied in (A) roll form,
B) pre-cut panels or (C) partially assembled gabions or mattresses.
roll form,When using roll
stock, begin the assembly process at Step 1.
When using pre-cut panels, proceed to Step 2. When using preassembled gabions, proceed to Step 3.


Panels may be cut to appropriate sizes
in thefield. When using roll stock, bottoms,
lids, fronts and backs may be rolled out in lengths up to 300'.
Ends, diaphragms, front and back panels are
placed upright on the bottom section of wire
mesh.


Secure panels by screwing spiral binders through the mesh openings in adjacent
panels.
18” Stiffeners should be placed inside at 12” intervals (4 per cell)and crimped over the line and cross wires on the front and side faces. None are needed in interior cells.


Secure panels by screwing spiral binders through the mesh openings in adjacent panels. After filling, close the lid and secure with spiral binders at the diaphragms, ends, front and back.


All illustrations depict a 3' x 3' x 6' gabion. Gabions constructed from roll stock may utilize continuous sections of welded wire mesh up to 300' long. Please review pages 1 & 2 for basic assembly instructions.



  • Our Clients
Follow :